News

CONTACT US

Tel: +86 512-6917030/extension8059

Fax: +86 512-69170128
Mobile: 13182604317
Contact: Xu Chunjian
E-mail: chunjian_xu@xinxintck.cn

Website: www.xinxintek.com


The use of plastic hollow board precautions and maintenance cleaning

Your current location: Home >> News >> common problem

The use of plastic hollow board precautions and maintenance cleaning

Release date:2016-12-05 Author: clicks:

First, the hollow board cleaning: cleaning must be below 60 ℃ warm water rinse. Cleaning with neutral detergent, does not allow the use of sunshine board erosion effect of the detergent. Requires a soft cloth or sponge dipped in neutral liquid gently scrub. Prohibit coarse cloth, brush, mop and other hard, sharp tools to implement cleaning. Not suitable cleaning agent is alkaline solution, it will erode the board. Banned esters, ketones, halogenated hydrocarbons and all substances that can dissolve or swell polycarbonate.

Followed by the hollow plate storage and transportation: to be kept in the room, never allowed to direct sunlight or rain; hand code put, put the height of not more than two meters. The board may not be heavy objects, there must not be between the hard objects. Storage room should be kept clean, dry, to avoid dust intrusion. Indoor should not be stored at the same time other chemicals. Do not damage or remove the protective film when storing. Transport must be flat on the floor area is larger than the clean sheet on the plate, if necessary, should be properly tied to avoid vibration and sliding, pay attention to protect the board edge does not damage and double-sided protective film remains intact.

Once again, the use of hollow board Note: The installation of the organizers must be printed on the protective film printed on the notes and notes to understand clearly, and explain to the operator, with particular attention to which side of the standard. Before installation, do not peel off the protective film, only along the board edge of the protective film will be lifted about 50mm, after the installation immediately peel off the protective film, such as must continue to protect the board, then first peel off the film, and then re-cover the protective film. Seal material of the sealing material should not damage the PC sunshine board. Seal belts should have good weather resistance and should not lose viscosity and mechanical strength for long periods of time. Do not polish or clean the sun with a strong alkali plate, do not use a hard brush to wipe the surface, so as to avoid the phenomenon of nap.

Related tags:Hollowplateseries

Recently Viewed: